menu 1 home home
menu 2 news
menu 3 articles
menu 4 wastewater
menu 5 industry
menu 6 on-line analysis
menu 7 in-situ analysis
menu 8 lab/portable
menu 9 sampling
menu 10 flow
menu 11 products
menu 12 water
menu 13 tech support
menu 14 info download
menu 15 contact
menu 16
 
NEW OPTICAL DISSOLVED OXYGEN SENSOR..


 

The InsiteIG Model 1000 dissolved oxygen analyzer is a unique system that combines advanced electronics with a solid-state optical sensor. No other dissolved oxygen system can compare with the features and benefits of this revolutionary design. The Model 10 sensor utilizes an optical technique that does not consume oxygen like all standard membrane sensors

MLSS Analyser

Dual channel MLSS analyser with both DO and SS also available

DO Analyser
Model 1000 DO Analyser
Model 1000 trial
InsiteIG Do Analyser on trial in USA
Insite Instrument Group analysers
 
11 things you need to know about the
MODEL 1000 DISSOLVED OXYGEN w/ MODEL 10 OPTICAL SENSOR

1
The sensor does not use replaceable membranes or cartridges. This will significantly reduce the maintenance time required to keep the system operational.
2
There are no consumables (membranes, electrolyte, and anode) so the cost of ownership is reduced.
3
The sensor does not require routine calibration, due to the fact that there is no anode that is oxidizing, decreasing maintenance time and increasing reliability.
4
Fouling of the sensor does not have an effect on accuracy so routine sensor cleaning is not required. This decreases maintenance and increases reliability.
5
There is no need for sensor preparation or initial calibration at start-up, reducing the amount of time required to get the system operational.
6
Increased reliability of the system allows for better control of aeration saving the customer up to 30% in the cost of aeration.
7
There is no minimum flow requirement allowing the sensor to be mounted in almost any location, especially helpful in fine bubble diffuser basins were there is minimum agitation.
8
The system has two isolated 4-20 (0-20) outputs, four relays, and a Modbus RTU output allowing the customer to interface with the analyzer in whatever way they desire.
9
The LCD display is backlit, and uses the high temperature and UV resistant glass and fill. There is a contrast adjust on the front panel. This will ensure that the display is always easily readable.
10
Initial setup of the analyzer is accomplished through plain English menus on the display allowing for quick, easy setup.
11
System accuracy is .05 PPM allowing for accurate monitoring of anoxic and anaerobic zones.

List of Articles : Applications using InsiteIG Optical DO sensors (WWTP Process)

 

 

 


Fluorescence Dissolved Oxygen monitoring technology that is not damaged by direct or indirect exposure to sunlight


SS Analyser
Model 1500 SS analyser for MLSS final effluent and river water monitoring


Hand held SS analyser

Handheld SS logging meter using the same SS sensor as the fixed site system is also available